Sensaphone fgd-W610-B WEB600 Battery Backup User Manual download pdf

WEB600

SenSaphone Battery Backup

Description & installation

The WEB600 Battery Backup module (FGD-W610-B) provides uninterrupted backup power when main

power fails. The module includes a rechargeable battery and charge control circuitry to keep the bat-

tery fully charged while connected to a powered WEB600. The module can provide up to 2 hours of

backup time in the event of a power failure. The battery module connects to the WEB600 using a short

cable included with the battery module. Simply connect the cable to the Battery Backup connector on the

WEB600. The unit will charge the battery and monitor its charge level. The percent charge can be viewed

on the Summary screen. Note that upon initial connection it may take up to 5 minutes for the WEB600

to discover that a battery has been connected. Once the WEB600 sees the battery it will enable the battery

channel on the Battery programming screen (see Zones menu).

To receive a low battery alarm you must enable Alarm Message Delivery and configure the Alarm Schedule

accordingly. You must also set a Low Alarm Limit – a minimum value of 20% is suggested. Once the bat-

tery reaches 0% the WEB600 will shutdown the system to protect the battery from deep discharge damage.

When main power is restored the Battery Backup module will begin to recharge the battery automatically.

Battery Maintenance

The battery in the FGD-W610-B is a 6V 1.3AH sealed lead-acid (SLA) battery. This battery will keep the

unit operating for approximately 2 hours when fully charged and under normal operating conditions.

Service life

Over time and with periodic use, the battery will begin to lose its capacity, resulting in less overall backup

time. Under normal operating conditions, three or four years of dependable service life can be expected or

between 200 and 1000 charge/discharge cycles, depending on the average depth of discharge. Eventually,

battery replacement will be required to maintain a dependable level of service.

1 2

Summary of Contents

Page 1 - SenSaphone Battery Backup

WEB600SenSaphone Battery BackupDescription & installationThe WEB600 Battery Backup module (FGD-W610-B) provides uninterrupted backup power when ma

Page 2 - SENSAPHONE

replacing the BatteryThe battery can be replaced by following the instructions listed below. Replace ONLY with a rechargeable 6V 1.3AH sealed lead-aci

Comments to this Manuals

No comments

Sensaphone fgd-W610-B WEB600 Battery Backup User Manual

Browse online or download User Manual for Hardware Sensaphone fgd-W610-B WEB600 Battery Backup. Sensaphone fgd-W610-B WEB600 Battery Backup User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Sensaphone fgd-W610-B WEB600 Battery Backup